Last week I finished some fabrication work for a S14 customer. I angle mounted his AEM gauges into the vent area on the HVAC panel. I also made a spot to fit his Greddy boost controller. I did this in the area below the HVAC controller where four buttons/panels typically reside. He didn’t mind getting rid of the security light panel and the blank panel… which sit on the outside corners. So I moved the rear defogger button and hazard button to the outside locations. I had to modify them since they needed to have a rounded outside corner to mount in the corner locations properly. I then bonded in ABS material and shaped it to form a housing for the boost controller. I have talked about this exact process on another customer’s project in the past… so I’m not going to go in-depth about it again. You can simply search for my Custom Interior Fabrication off to the left if you want to see step-by-step process.
I also fit his Greddy turbo timer into the cluster shroud on the right side. There use to be a couple of OEM buttons located in that area that were no longer of use to the customer. So I removed those, plastic bonded the area closed then opened an area back up to fit the turbo timer.
Broadfield's Blog 